Puggle

A A A A Author Topic: Length of Camshaft Splines - CX650  (Read 43 times)

Barocca

Length of Camshaft Splines - CX650
« Started on: 27-Jul-20, 14:03 »
I'm trying to do a final check prior to doing a "Shep" mechanical seal fix.  I believe that the thrust washer is already sitting on the camshaft and partly covering the splines (see photo).  I have about 6.3mm of spline protruding past (what I believe to be) the washer.  This would mean about 8 to 8.5 mm of spline protruding with no washer in place.  Other posts have asked similar questions (for instance https://australiancx.asn.au/forum/index.php?topic=14391.0) but I have yet to see a verified measurement from a reliable source.  So my question is; can I assume that the thrust washer is in place and confidently proceed with the seal replacement and reassembly?

CX PHREAK

Re: Length of Camshaft Splines - CX650
« Reply #1 on: 27-Jul-20, 15:17 »
Your thrust washer is present on your cam in the picture Dave.

 


Website and forum protected by
┬áSTOP FORUM SPAM     Bad Behavior     Let's Encrypt

Puggle
SimplePortal 2.3.6 © 2008-2014, SimplePortal